 |
See how simple
it is to assemble an Origami Folding Dinghy
Step One:
Open one
side out as far as
possible. To stop the
panel from falling
inwards, gently angle the
bottom of it slightly
inboard.
side out as far as
possible. To stop the
panel from falling
inwards, gently angle the
bottom of it slightly
inboard.
Step Two: Pull out the
other
side panel.
side panel.
Step Three: Let the floors
drop
gently into the bottom of the
dinghy.
gently into the bottom of the
dinghy.
Step Six: Reach under the
floor panels for the aft floor
supports and slide them into
position between the floor
guides. Knock them into
place until they are at 90
degrees to the keel.
floor panels for the aft floor
supports and slide them into
position between the floor
guides. Knock them into
place until they are at 90
degrees to the keel.
Step Five: Locate the other
end of the
floor support in the other side and knock
into place until it is at 90 degrees to the
keel.
floor support in the other side and knock
into place until it is at 90 degrees to the
keel.
Step Four: Insert the
forward
floor support under the floor
panels with the glued square
underneath. Locate one end of
the support in between the
floor guides on the side panel.
floor support under the floor
panels with the glued square
underneath. Locate one end of
the support in between the
floor guides on the side panel.